Results 1 to 2 of 2
  1. #1
    Member
    Join Date
    Feb 2006
    Posts
    1
    Points
    0

    Default Problem after bios change

    Hi guys I was in my computers bios and changed dram setting to 133mhz now my computer will not start at all.
    I do not get a POST test or any kind of error. Also it does not load from the hard drive, though its running. At this point i dont know if its a hardware or CMOS problem i tried to use the jumper to reset it but nothing. How can i get my pc running again!
    I am running a p4x2-av motherboard.
    http://www.doomgold.com/pcstuff/P4XA...ER%20GUIDE.pdf

    Any help urgently needed.

  2. #2
    Member
    Join Date
    Dec 2002
    Posts
    12,000
    Points
    1191

    Default

    Try removing the CMOS battery for 30 minutes or so. That possible could reset the BIOS back to defalut.

    BG